flathead screwdriver - Canon Power Shot SD850 IS Camera Lens Manual Replacemet

Posted in Canon on 9th December 2012

Canon Power Shot SD850 IS Camera Lens Manual Replacemet
Download
Tools: Metal Clips (1)
00 Phillips screwdriver (1)
Small Phillips head screwdriver (1)
Spudger (1)
Summary use this guide for removing a lens broken his Canon PowerShot SD850 IS

Step 1 – abduction case remove 4 screws: two 2.8 mm Phillips #00 at the bottom of the camera.Two 2.75 mm Phillips #00 on the opposite side of the belt.
Step 2 open the A / V digital out of the door on the side of the belt. Remove the 2.75 mm Phillips #00 in A / V digital out of the door on the side of the bracelet.

Step 3 in the bottom of the camera, use fingernail for dragging the gray tab until the edge of the Chamber. Slide the grey door and pull open the door. Phillips #00 remove the 8,35 mm next to the Brown tab that holds the battery.
Step 4 pull gently to cover directly from the camera. This will expose the wiring in the front of the camera.

Step 5 remove the 2.75 mm Phillips #00 next / v digital output.
Step 6 slide the new body (with reference of guard) off reveal LCD and new wiring.

Step 7 – remove screen LCD 1.75 mm Phillips #00 located in the top left of the LCD screen.
Step 8 remove the two 3. 4 mm Phillips head #00 at the bottom of the camera.

Step 9 remove the two frames of metal holding the LCD in place.
Step 10 LCD now must be accompanied only with two LCD datacables. Raise the use of squares from left a spudger or a small screwdriver to turn the connector upwards Black part screen to unlock. Carefully slide the data connector cable.

Step 11 LCD should always be connected via the cable for backlight. To remove the backlight cable, use a spudger or a small flathead screwdriver to unlock the thebacklight cable.Carefully slide the backlight cable.The LCD screen can now be completely separated from the camera.
Step 12 LCD screen and case are now in three pieces: screenLCD screen LCD LCD of back frame of the housing can now be retired and fixed/replaced.

Step 13 – Flash unit remove the 1.85 m #00 Phillips located in the left side of the camera.
Step 14 use a set of pliers pliers to remove the speaker at the top of the camera in the flash. Then, use tweezers to carefully remove the speaker wire to their respective owners.

Step 15 use a spudger or a Flathead crew driver to remove the lens from the camera cable located in the the front of the camera.
Step 16 use a spudger or Flathead screwdriver and carefully remove the first flash of the bottom of the wire from the wire. The 2 white wire pin appears (use black spudger / insert and exerts upward pressures). For yellow, apply a horizontal pressure. Then use a spudger or a Flathead screwdriver and remove the second wire of flash.

The componentfrom the rest of the camera’s flash step 17 remove gently. Use a spudger or a flatheadscrewdriver and carefully age a piece of plastic on top of the flashunit.Flash can now be removed and replaced.Make sure not to touch thecapacitor tied to hand theflash because there is a police officer who maintains a quota!

Step 18-camera remove the four screws in the back of the camera: 6.15 #00 Phillips 2.75 mm #00 Phillips2.15 m #00 2.7 mm Phillips #00 Phillips

Step 19 use a spudger or a Flathead screwdriver and carefully on the bulb in the front of the camera at the top of the camera lens.
Step 20 remove gently the camera than the rest of the camera lens.
To back up your device, follow these instructions in reverse order.