Sony - Gadget Owner's manual

Sony Cyber-shot DSCW290 Lens Assembly Replacing Manual

Posted in Sony on 26th January 2013

Sony Cyber-shot DSCW290 Lens Assembly Replacing Manual

OVERVIEW
To remove lens Assembly, you should be removed from the knowledge base
the camera. (Refer to previous guides)
Step 1 – battery
Find the door labeled “open” in
the left side of the bottom of the
camera.
Slide the door in the direction that
the arrow. The door is
open up to the outside on their own.

Step 2
Slide the blue tab to release
the battery. Slide the battery out of the
the camera.
Step 3 – outside
Replace the door and rotate 180 degrees of the camera. Should always look at the bottom of
the camera.
Remove the four screws of 2, 5 mm Philips #0.

Step 4
Turn the camera in the left side panel. (It says 5 x Optical Zoom)
Screw two 2.5 mm Philips #0.
Need to remove the screws with the clips when they are screws
almost not.
Step 5
Turn right towards you to the camera.
Screw two 2.5 mm Philips #0.
Need to remove the screws with the clips when they are screws
almost not.
Step 6
Rotate the camera until the rear
facing you.
Pull straight to the back of the case
from the LCD screen.
Step 7
Turn on the camera so that the left side toward you.
Separate the left panel to turn off the camera.

Step 8
Turn on the camera so that the front of the camera towards you.
Pull the front case directly from the camera.
Right side panel may fall when removing the front panel.
Step 9
Turn on the camera so that the right side is facing you.
Pull the right away from the rest of the panel of the camera.
Step 10
This is what the camera should look like now that you have removed all the homes
sides.
Step 11 – screen LCD Assembly
Gently pull the LCD screen and its case
away from the motherboard to
shown.
Do not pull one
Ribbon cables.
Step 12
By pulling the small ribbon cable where small disconnect the ribbon cable is
It connects to the motherboard.
Do not use excessive force to remove the cable since it can cause a tear.
Step 13
Disconnect the wide ribbon cable by pulling the cable of wide ribbon that connects to the
the base plate.
Step 14
Pull up the LCD screen and its carter from afar
the rest of the camera.
Step 15 – Flash bulb
Turn on the camera to back is facing you.
Remove the 2 screws, 5 mm #0 at the top of the camera.
Step 16
Tilt the cover up and out.
Carefully remove the right panel ribbon cable upper pulling where camera cable
connects to the top of the page.
Be sure to hold the camera with your thumb on the white square to ensure the
the base plate ribbon cable is not disconnected.
Carefully pull the left ribbon panel cable upper chamber where the cable
connects to the top of the page.
Step 17 – lens system
Flash capacitors are dangerous! Be careful when removing the condenser
the camera. You can get badly impressed!
Remove all condenser lenses.
Carefully place condenser far where he works.
Step 18
Carefully disconnect the upper Ribbon from plate wire base where pulling cable
It connects to the motherboard.
Step 19
Disconnect the remaining Cap tape son pulling gently at the base of the place where the cable
It connects to the motherboard.
Step 20
Pull the lens away from the mounting base plate.
You have now deleted all of the camera lens.
To back up your device, follow these instructions in reverse order. Donwload HERE full Guide

Sony CCD-TR81 Lens Assembly Replacement Guide

Posted in Sony on 23rd December 2012

Sony CCD-TR81 Lens Assembly Replacement Guide

Tools: Pliers metal (1) Phillips #0 Phillips (1) #000 (1) screwdriver Phillips #1 Phillips 00 (1) (1) plastic screwdriver opening Tools (1)
Summary if the lens of the video camera or gets cloudy, replacement can be expensive and confusing. This guide shows how you can access the entire lens on their own to make the rapid replacement. To access all of the lens that you have removed the battery and the outside

Sony CCD-TR81 Lens Assembly Replacement Guide

Step 1 – Viewer to access battery battery lift.
Step 2 press the release button on the battery. All by pressing the button on the battery, slide the battery towards the left.

Step 3 remove the battery out of video camera.
Step 4 – open external cases cover the tape. Unscrew the screws on the outside wall of 14. Three are in the high face2x6.8mm and 1X4.54mm, three on the left side 1×4.54mm, 1×5.3mm and seven on the bottom face 5×4.54mm and 2×6.77mm.

Follow step 5 screws. Five right, bottom up, 3×4.54mm2x5.70mm. One in the rear 1×4.54mm.
Step 6 remove the plastic strip cover by lifting up and away from the base of the camera.

Step 7 disconnect the microphone Assembly of the camerabase. Do not pull too hard because the cables are still connected. Step 8 pull out the bottom of the camera casing.

Step 9 remove three screws located marked on the right side of the video camera 3×4.54mm.
Step 10 remove the screw in front of the camera video 1×3.6mm printed circuits.

Step 11 pull under the microphone mounting audio/video inputs. Tickets will stillbe on the circuit.
Step 12 remove two screws remaining cases in the front of the Chamber of 2×3.63mm.

Step 13 using metal clamps, exit the box of plastic of the connector on the front panel. Reuse the metal clips from the junction box at the bottom of the camera. Now the right side of the box can be removed by pulling to the right.
Step 14 – lens installation remove three screws from the plate on the left side of the camera video 3×3.6mm Circuit.

Step 15 using metallic, leave the plastic of the connector box. Pull the upper part of the cover. Attention, will be always connected to a wire band.
Step 16 remove the three screws around the lens mount 2×4.45mm 1×5.36mm.

Step 17 remove the three screws at the bottom of the lens of the set 2×6.00mm and 1×5.46mm. Attention do not break the son of the band. Both are gold.
Step deck Grand Assembly 18 lift lens. Loosen the three screws in the top 2×5.31mm and 1×6.07mm. Remove the last remaining screw with screwdriver #000 1×6.06mm. Lens must be disconnected from the lens.

Step 19 once the objective has been removed fromlens installation, repair or replacement is possible.

To back up your device, follow these instructions in reverse order.

Download HERE for this Guide Sony CCD-TR81 Lens Assembly Replacement Guide